BOMBARDIER Alpine II Manual do Operador descarregar pdf (Página 47)

Drive pulley

Inspection and cleaning

must

be per-

formed

by

an authorized dealer at the

end

of

each season.

Engine

Engine internal parts

must

be lubricat-

ed

to

protect them from possible rust

formation during the storage period.

To

perform the storage procedures pro-

ceed

as

follows:

1.

Lift the rear

of

the vehicle and sup-

port it

off

the ground .

..A. WARNING :

Ensure

the tracks

are

T free

of

all particles which could

be

thrown out while

it

is

rotating. Keep

hands, tools,

feet

and clothing clear

of tracks. Ensure no one

is

standing

in

close proximity

to

the vehicle.

2.

Start the engine and allow it

to

run

at idle speed until the engine reaches

its operational temperature.

3.

Stop the engine.

4.

To

prevent gasoline from draining,

primer button should be pushed all

the

way.

5. Disconnect the outlet primer hose

from the primer

valve.

A017

002

014

(Oblique

coupling}

(Straight

coupling}

6.

Insert storage oil

(PIN

496

0141

00)

can hose into primer outlet hose.

7. Restart engine and run at idle.

8.

Inject storage oil until the engine dies

or until a sufficient quantity

of

oil has

entered the engine (approximately

30

seconds).

9. With the engine stopped, remove the

spark plugs and pour approximately

85

ml

(3 imp oz)

of

Bombardier oil

into each cylinder.

10. Crank slowly

two

or three revolu-

tions

to

lubricate cylinders.

11

. Reinstall the spark plus and the out-

let primer hose.

Do not

run

engine during storage pe-

riod.

Fuel

tank

and carburetor

Remove the cap then, using a syphon,

remove the gasoline from tank.

..A. WARNING :Gasoline

is

flamma-

T ble and explosive under certain

conditions. Always manipulate

in

a

well ventilated area. Do not smoke

or

allow open flames or sparks

in

the vi-

cinity.

The carburetor must be dried

out

com-

pletely to prevent gum formation during

the storage period.

Once the fuel tank

is

emptied, remove

the float chamber drain plug from car-

buretor. Drain carburetor and reinstall

plug.

A002

002

010

Plug

Check

all

fuel lines, replace if necessary.

45

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 57 58

Comentários a estes Manuais

Sem comentários